B1 GENIUS10_How_To_XS

GENIUS10

SUPPORT.

GENIUS10

Advanced Diagnostics.

High Voltage

The battery voltage is too high for the selected charge mode. Check the battery and charge mode.

Bad Battery

There is a possible battery short or the battery will not hold a charge. Have the battery checked by a professional.

Reverse Polarity

Charger is connected to the battery in reverse. Reverse the connections.

Standby Mode

The charger is in standby mode or the battery voltage is too low for the charger to detect.

Temperature

All Error LED’s will flash. Internal / external temperature is too high / low. Charger will resume once the temperature is back within operating limits.

GENIUS10

Advanced Charging.

12V Mode

Used for 12V wet cell, gel, enhanced flooded, maintenance- free, & calcium batteries.

12V AGM Mode

Used for 12V AGM batteries.

12V Lithium Mode

Used for 12V lithium- ion batteries (including lithium iron phosphate). Only for batteries with Battery Management Systems (BMS).

6V Mode

Used for 6V wet cell, gel, enhanced flooded, maintenance-free, & calcium batteries.

6V AGM

Used for 6V AGM batteries.

Force Mode

Used to charge batteries below 1V. All charge mode LED’s will flash and the selected mode will illuminate.

12V Supply

Converts to a DC power supply for powering any 12V DC device.

12V Repair Mode

Used to repair old, idle, damaged, stratified, or sulfated batteries.

GENIUS10

Charge Levels.

25% Charged

Pulsing Red 25% - The battery is less than 25% charged.

50% Charged

Pulsing Red 50% - The battery is less than 50% charged.

75% Charged

Pulsing Orange - The battery is less than 75% charged.

100% Charged

Pulsing Green - Bulk Charge complete, optimizing battery for extended life.

Maintenance

Slow Pulsing Green - After the battery is fully charged, the charger will continue to provide ongoing maintenance and optimization until disconnected.

Videos

How to change modes on your NOCO GENIUS10

Learn how to change charging modes on your NOCO GENIUS10 Smart Battery Charger. Easily switch between Standby, 12V, 12V AGM, 12V Lithium, 6V, 12V Repair, and 12V Supply.
Learn how to use force mode on your NOCO GENIUS10 Smart Battery Charger. Manually begin charging batteries below 1-volt.

More Videos

GENIUS

FAQ

DO MORE WITH GENIUS

ACCESSORIES.

NOCO GENIUS Battery Chargers are compatible with a variety of accessories to expand your capabilities. Get complete protection with the universal EVA protection case for GENIUS. The following X-Connect accessories are compatible with the all-new GENIUS series:

Cookies On This Site

Our website uses cookies, pixels, and similar technology (“Cookies”) to make the website work and to improve your online experience. Cookies that are essential for the functioning of our website are always active and cannot be turned off. With your consent, however, we may also use non-essential Cookies to improve user experience, personalize advertisements, and analyze website traffic. By clicking “Accept All,” you consent to our use of all Cookies, including these non-essential Cookies. You may block non-essential Cookies by clicking “Reject,” or change your cookie settings by clicking “Preferences.”

By using our website, you acknowledge this notice, and by clicking “Accept All,” “Reject,” or “Preferences,” you agree to our Website Terms of Use. See our Cookie Policy and Privacy Policy to learn more.