GENIUS.

USING FORCE MODE ON GENIUSPRO.

Using Force Mode on NOCO GeniusPro.

Using Force Mode on NOCO GeniusPro.

NOCO GeniusPro is able to detect and charge dead batteries as low as 1-volt. For extremely dead batteries lower than 1-volt, manually turn on Force Mode to detect and charge batteries all the way down to zero volts.

WHEN USING FORCE MODE ALL SAFETY FEATURES WILL BE DISABLED.


To access Force Mode:

  • Make sure the charger is connected to AC power and has a secure connection to the battery.
  • Press and hold the Mode Button for approximately 5 seconds until all available modes light up.
  • Press the Mode Button to toggle through the list to select the correct mode.
  • The charge LEDs will begin to chase, indicating Force Mode is active.
  • Force Mode will stay active for 5 minutes, then return to normal operation.


If the charger returns to Standby after the Force Charge cycle it likely means the battery should be tested by a professional.

Cookies On This Site

Our website uses cookies, pixels, and similar technology (“Cookies”) to make the website work and to improve your online experience. Cookies that are essential for the functioning of our website are always active and cannot be turned off. With your consent, however, we may also use non-essential Cookies to improve user experience, personalize advertisements, and analyze website traffic. By clicking “Accept All,” you consent to our use of all Cookies, including these non-essential Cookies. You may block non-essential Cookies by clicking “Reject,” or change your cookie settings by clicking “Preferences.”

By using our website, you acknowledge this notice, and by clicking “Accept All,” “Reject,” or “Preferences,” you agree to our Website Terms of Use. See our Cookie Policy and Privacy Policy to learn more.