GENIUS.
PRECAUTIONS TO TAKE BEFORE CHARGING.
Use the following precautions when you work near lead-acid batteries.
General Safety Precautions:
Before Charging:
- Turn off or disconnect all accessories in the vehicle to avoid an electric arc (or spark). Always remove the cable connected to the grounded terminal first.
- Ensure the area around the battery is well-ventilated while charging. If needed, use a non-metallic material to disperse any gas buildup.
- Clean the battery terminals if necessary.
Be careful to prevent corrosion or debris from contacting your skin or eyes.
- Check the water level if the battery is not sealed.
Add distilled water to each cell (if required) until the electrolyte reaches the level specified by the manufacturer. Do not overfill.
For batteries without cell caps, such as VRLA (valve regulated lead-acid) batteries, follow the manufacturer’s specific charging instructions.
- Read the battery manufacturer’s precautions and recommended charging rates before charging.
- Verify the battery’s voltage using the vehicle owner's manual and make sure the charger is set to the correct voltage mode.
- Connect and disconnect the DC output cables only when the charger is in STANDBY and the AC cord has been removed from the electrical outlet.
Never allow the battery clamps or eyelet terminal connectors to touch each other.
Locating the Battery Charger:
1 | Place the battery charger as far away from the battery as possible.
2 | Never position the charger directly above the battery.
Gases from the battery can rise and corrode or damage the charger.
Never place a battery on top of the charger.
3 | Prevent any battery acid from contacting the charger.
4 | Do not operate the charger in a closed or poorly ventilated area.










