Jump Starting
Read below to begin jump starting your vehicle with a NOCO Genius Boost.
1.) Verify the voltage and chemistry of the battery.
2.) Connect the X-Connect Clamps to the Boost if not already connected.
3.) Confirm the battery clamps are connected to the correct polarity battery terminals.
4.) Disable the vehicle's accessories.
Make sure all of the vehicle’s power loads (headlights, radio, air conditioning, etc.) are turned off before attempting to jump start the vehicle.
5.) Press the Power Button to begin jump starting.
All LEDs will flash, indicating that all LEDs are properly functioning. If you are properly connected to the battery, the White Boost LED will illuminate and the four Charge LEDs will start chasing. If the battery clamps are connected in reverse, the Red Error LED will illuminate. Reverse the connections to clear this error and then the White Boost LED will illuminate. The White Boost LED is illuminated when the Boost is ready to jump start your vehicle.
6.) Try jump starting the vehicle.
Most vehicles will immediately start. Some vehicles may require Boost to be connected for up to 30 seconds before starting. If the vehicle does not start right away, wait 20-30 seconds and try again. Do not attempt more than five (5) consecutive jump starts within a fifteen (15) minute period. Allow Boost to rest for fifteen (15) minutes before attempting to jump start the vehicle again.
7.) Once you have started your vehicle, disconnect the battery clamps, and remove Boost.
Monday through Friday
The NOCO Company 30339 Diamond Parkway #102 Glenwillow, OH 44139-5400 United States of America