How to Use Force Mode on GeniusPRO

Learn how to use Force Mode on NOCO GeniusPRO.

NOCO GeniusPro is able to detect and charge dead batteries as low as 1-volt. For extremely dead batteries lower than 1-volt, manually turn on Force Mode to detect and charge batteries all the way down to zero volts.

WHEN USING FORCE MODE ALL SAFETY FEATURES WILL BE DISABLED.

To access Force Mode:

Make sure the charger is connected to AC power and has a secure connection to the battery.
Press and hold the Mode Button for approximately 5 seconds until all available modes light up.
Press the Mode Button to toggle through the list to select the correct mode.
The charge LEDs will begin to chase, indicating Force Mode is active.
Force Mode will stay active for 5 minutes, then return to normal operation.

If the charger returns to Standby after the Force Charge cycle it likely means the battery should be tested by a professional.

Watch the video below to learn more.

Chat 8:00AM to 4:00PM PDT
Monday through Friday

Average Response Within 1
Business Day

Request A Callback

It's OK to respond via email for a faster response.

Click for emergency contact information.

Emergency Contact Information

1.800.456.6626 8:00AM to 4:00PM PDT
Monday through Friday

For non-urgent support, please

For Fastest Response, Use 'Chat' or 'Send a Message' Above

Write Us

The NOCO Company 30339 Diamond Parkway #102 Glenwillow, OH 44139-5400 United States of America