GBC012   Boost Settings Keeper

Boost Settings Keeper

The GBC012 OBD-II 12V Boost Settings Keeper allows you to disconnect your vehicle's battery without losing onboard electronic settings, such as radio and clock settings, seat positions, alarms, GPS, keyless entry codes and more. It's simple to use. Just connect the OBD-II 12V Boost Settings Keeper to the XGC 12-Volt Out Port on a GB70 or GB150 Ultra Safe Lithium Jump Starter and power on the jump starter. It features a Type-A OBD-II 16-Pin diagnostic connector for vehicles with a 12-volt supply voltage per SAE J1962 specification.
  • DANGER: NEVER START A VEHICLE OR CHARGE THE VEHICLE’S BATTERY WHILE CONNECTED. WHEN USED IMPROPERLY AND/OR AGAINST RECOMMENDED USE, IT MAY RESULT IN PROPERTY DAMAGE, SERIOUS INJURY, OR DEATH. Always turn off as many electrical loads as possible before using. (ie. Headlights, AC, Radio, etc.)
  • WARNING: This product is fused at 10 Amps. Always check with the vehicle manufacturer to verify the maximum current supported through the OBDII port. Do not use if the vehicle’s OBDII fuse is below 10A and/or shares a fuse with the ECU or other sensitive equipment.
  • Maintains onboard vehicle computer systems; perfect when disconnecting the battery or making battery changes.
  • Works through the XGC OUT port on NOCO GB70 and GB150 Jump Starters.
  • Compatible with any OBDII port (All vehicles built after 1995)
  • Maintains voltage continuity to vehicle onboard computer; retains clock, radio, and seat memory.
  • WARNING: California’s Proposition 65
$19.95
MSRP $19.95
In Stock
UPC: 0-46221-17017-7
0.17lbs | 5.12 × 1.57 × 3.23
5/5
1 Review

100% Of Reviewers Recommend This Product

Compatible with the NOCO Genius GB70 & GB150 Boost Jump Starters

Save Your Settings.

Keep on-board computer information while you change your battery.

Safely disconnect and replace your car battery without losing settings such as clock, radio, seat position, and more. Simply plug the GBC012 Memory Keeper into your vehicle's OBDII port located under the steering wheel, and hook up the XGC IN end to a NOCO GB70 or GB150 jump starter. Power on the NOCO Genius Boost and you are free to disconnect your vehicle's battery.

Change your battery, not your settings.

Connect the Boost Settings Keeper while replacing your battery.

As soon as a car’s battery is disconnected, the onboard computer and electronics risk losing programmed settings. To retain the settings, a replacement power source is required while the battery is disconnected. Use the GBC012 to connect BOOST HD (GB70) or Boost Pro (GB150) to the vehicle’s OBDII port to save onboard computer settings, while disconnecting or replacing the battery. Shop All Boost Models

Protected.

In-line replaceable fuse offers an additional layer of safety.

The GBC012 includes a 10A in-line replaceable fuse that helps prevent damage to your vehicle and Boost by limiting the amount of current. The 10A fuse should blow before the vehicle’s OBDII fuse, making it easier to replace in the event of overload. As a reminder, always turn off as many electrical loads as possible before using the Boost Settings Keeper. (ie. Headlights, AC, Radio, etc.)

Technical Specifications

Input

XGC IN

Output

OBDII Connector

Length

30 inches

Fuse

10 Amp Regular Blade ATC

Weight

0.17 pounds

Compatible Boost Models

GB70
GB150